Tie Menu (Default Menu); Using The Lcd Display - Extron electronics Matrix 200 User Manual

Tie Menu (default menu)

Using the LCD Display

_______ The symbol > is used in many of the Matrix 200 menus as a cursor point from
4-3
Chapter 4 • Using the Front Panel Controller
The Tie Menu is the default menu for the Matrix 200. Used to make all input/
output connections, this menu has four submenus (Tie levels): Tie Gang, Tie All,
Tie Group, and the Tie Individual Menus. See examples on the next page.
How to select the Default Menu. This menu is displayed automatically
(immediately after the Power On message) when the Matrix 200 is powered on.
The Default menu may be selected at any time during normal operation by
pressing Escape.
In the illustration below, the numbers 1 thru 8 in the top row are fixed output
numbers. The space below each output position will contain the number of the
input to be tied (connected) to that output. These numbers can vary from 1
through 8, depending on how the Matrix 200 is configured. The example here
shows input #3 tied to output #1 with no inputs tied to the other seven outputs.
The picture above shows some position numbers. For example, the upper left
position is 0,0. The cursor (indicated by the underline character "_") is at 0,3.
which the function to the right may be changed.
Throughout this section, references are made to
the positions in the LCD display:
• The top row is zero (0), and the bottom row
is one (1).
• The left-most position is zero (0), and the
right-most is 15.
Extron • Matrix 200 • User's Manual