Installing A Blank Front Panel - Extron electronics Matrix 200 User Manual

Installing a Blank Front Panel

Caution:
_______ When installing a new front
2-5
Remove the cover (see "Removing the Matrix 200 Cover" on page 2-2) and then
do the following:
1. Disconnect the modular cable from the plug on the FPC to the RJ45 connector
on the Matrix 200 main controller board. See
connector location.
2. Remove the four
No.10 attaching
screws and dress
washers (items &
in pictures below)
from the front panel
and remove the
panel.
Take care to remove the four spacers from the rear of the panel. See picture
below, left.
3. Position the blank panel on the front of the Matrix 200 with a
spacer behind the panel for each screw. Install the four screws and
dress washers. (See
easier by placing the Matrix face-up, being careful to protect the
BNC
connectors
from damage.
4. Connect the
Power Indicator
cable from the
Blank Front Panel to J13
on the right side of the
main controller board.
See in the picture to
the right.
5. Reverse the procedure for
removing the cover to
reassemble the Matrix.
panel, it may be necessary to reposition the side panels to align the screw
holes.
Chapter 2 • Hardware Installation
in the picture below for the
& in left picture.) This may be made
If the FPC is to be installed remotely, refer to
the following procedure.
Extron • Matrix 200 • User's Manual