Installing A Front Panel Controller - Extron electronics Matrix 200 User Manual

Installing a Front Panel Controller

Caution:
_______ When installing a new front
2-3
Remove the cover (see "Removing the Matrix 200 Cover" on page 2-2) and then
do the following:
1. Remove the four
No.10 screws and
dress washers (items
& ) from the
Blank Front Panel.
Take care to remove the four spacers from the rear of the panel. See picture
below, left.
2. Disconnect the Power Indicator cable from J13 on the right side of the main
controller board and remove the panel. See
3. Position the FPC on the front of the Matrix 200, with a spacer behind each
screw. Install the four screws and dress washers (items
be made easier by placing the Matrix face-up, being careful to protect the
BNC connectors from damage.
4. Connect the modular
cable from the plug on
the FPC to the RJ45
connector on the
Matrix 200 main
controller board. See
in the picture to the right
for connector location.
5. Reverse the above
procedure to put the
Matrix back together.
panel, it may be necessary to reposition the side panels to align the screw
holes.
Chapter 2 • Hardware Installation
The mounted Front Panel Controller.
Extron • Matrix 200 • User's Manual
in the picture below right.
& ). This may