Reports (Matrix-To-Host; Report0 (70H) - Status; Report1 (71H) - New Controlling Port - Extron electronics Matrix 200 User Manual

Reports (Matrix-to-Host)

Report0 (70h) — Status
Status Byte 1:
Status Byte 2:
Status Byte 3:
Report1 (71h) — New Controlling Port
B-23
This report is broadcast when a change in internal status is detected.
Format: RPRT0, StsB1, StsB2, StsB3, Cks1, Cks2, EOT
7 6
Bit usage: 1 Prg
Where: StsB1, Bit 0 Power On/Off status — 0 = powered on;
StsB1, Bit 1 Backup battery status — 0 = battery okay;
StsB1, Bit 2 Genlock Signal — 0 = detected; 1 = not detected
StsB1, Bit 3 Vertical interval switching — 0 = disabled; 1 = enabled
StsB, 1 Bit 4 Slave status — 0 = stand alone unit or master controller
StsB1, Bit 5 Sequence running — 0 = not running; 1 = running
StsB1, Bit 6 Program status — 0 = no program event pending;
7 6
Bit usage: 1 0
Where: StsB2, Bit 0 Power Supply in use — 0 = Backup Power;
StsB2, Bit 1 Executive mode status — 0 = Executive mode Off;
StsB2, Bit 2 Hardware Security status — 0 = locked; 1 = unlocked
(available to user, when unlocked)
StsB2, Bit 3 Checksum status — 0 = Checksum enabled
StsB2, Bits 4-6 are reserved (should be zero)
7 6
Bit usage: 1 0
Where: StsB3, Bit 0 Software Security status — 0 = locked; 1 = unlocked
(available to user, when unlocked)
StsB3, Bits 1 thru 6 are reserved (should be zero)
This report is broadcast when a change in the connections (current or presets) or
the operating mode is requested (and implemented) by a new port. Commands
5, 7, 9, 11, 12, 14, 18, 25, 27, and 29 will cause this report to be broadcast.
Format: RPRT1, Port#, Cks1, Cks2, EOT
Where: Port# as follows ...
80h host controller (RS-232)
81h n/a
82h standard front panel controller port
83h secondary front panel controller port
This concludes the programming section.
Appendix B • Programming Guide
5 4 3 2
Seq Slv Ver Gnlk
1 = powered off
1 = battery low
1 = slave in a compound matrix
1 = program event pending
(timer is set)
5 4 3 2
0 0 Cksm H-Sec Exec
1 = Main Power
1 = Executive mode On
1 = Checksum disabled
5 4 3 2
0 0 0 0
Extron • Matrix 200 • User's Manual
1 0
Batt Pwr
1 0
Ps
1 0
0 S-Sec