Genlock Connections; Rgb Input Connections - Extron electronics Matrix 200 User Manual

Chapter 3 • Rear Panel Connections

Genlock Connections

RGB Input Connections

Without Audio
With Audio
Extron • Matrix 200 • User's Manual
The Matrix 200 is
designed to use an
external Genlock signal
to synchronize composite
video or S-video
switching. If connected,
Genlock can be
programmed either from
the optional Front Panel
Controller, or from a Host
system (through the RS-232/
RS-422 port).
The illustration here shows the
Genlock connections. The
Genlock Out connector simply
allows the signal to be passed
on to another video device; it
does not have to be connected
for Matrix operation.
All RGB input and output connections to the Matrix 200 are made with BNC type
connectors. Many types of RGB output devices (scan doublers, document
cameras, etc.), including most computers, do not have BNC video output
connectors. If not, a suitable adapter or an Extron computer-video interface
should be used to adapt the device output to the BNC input of the Matrix 200.
With the proper adapter, the RGB and Sync signals can be connected directly to
the R, G, B, H, V inputs of the switcher. If the RGB signal is using the Sync-on-
Green channel, connect the RGB cables to the switcher without using the sync
channels.
RGB input connections to the Matrix 200 can be made using the following
combinations:
RGsB - Red, Sync-on-Green, Blue
RGBS - Red, Green, Blue, and Composite Sync
RGBHV - Red, Green, Blue, H&V Sync
RGsB with R&L Audio - Red, Green, Blue, and Audio Follow
RGBS with R&L Audio - Red, Green, Blue, Sync and Audio Follow
RGBHV with R&L Audio - Red, Green, Blue, H&V Sync and Audio Follow
The following three pages illustrate examples for the above combinations with
Right and Left Audio connections.
FUSE: 250V ~0.8A TT
REDUNDANT POWER AC POWER INPUT
100-240V ~0.5A MAX 50/60 Hz
!
DISCONNECT ALL POWER CORDS BEFORE SERVICING
3-2