GE P2S975 Owner's Manual page 13

Usingthe clock, timer and range lock-out gecom
Make sure the clock is set to the
correct time of da,¢
ToSet the Clock
The clock must be set to the correct time
of day fin" the autonmfic oven tinting
flmctions to work i)roperly. The time el
day cannot be changed during a timed
baking or self=cleaning cycle,
[] Touch the CLOCK pad,
[] Touch the number pads.
[] Touch the START pad.
The timer is a minute timer onl,¢
The timer does not control oven
operations. The maximum setting on
flTetimer is 9 hours and 59minutes.
ToSet the Timer
[]
[]
[]
Touch the KITCHEN TIMER
ON/OFF pad.
Touch the nmnber pads tmfil the
_lIIlOtlIlt of time yell W_lIlt shows
in the display. For example, to set
2 hom_ and 45 minutes, touch 2, 4
and
5 in that
orde_: If you make a
mistnke touch the KITCHEN
TIMER
ON/OFF pad and begin again.
Touch the STARTpad.
After touching theSTART pad,SETdisappears,
this tellsyouthetimeis counting down, a lthough
thedisplay doesnot change untiloneminutehas
passedSeconds wi//notbe shownin thedisplay
untilthe/astmlbuteiscounting down.
[] _Ahen the timer reaches :/_, the
control will beep 3 tim es followed
by one beep eveI T 6 seconds until
the KITCHENTIMERON/OFF pad is
touched.
The 6-second tonecanbe cance/ed b y fo//owlbg
thestepsin theSpecial f eatures of youroven
control s ectionunderTones a t theEndeta
Timed Cycle.
To Reset the Timer
If tile display is still showing tile time
remaining, you may change it by
touching the KITCHEN TIMER ON/OFF pad,
then touch tile number pads tmtil tile
time you want appea_s in the display,
If tile remaining time is not in tile display
(clock, delay stnrt or cooking time are in
the display), recall the remaining time by
touching the
KITCHEN TIMER
ON/OFF
pad
and then touching tile number pads to
enter the new [lille veil want.
ToCancel the Timer
Touch tile KITCHEN TIMERON/OFF
pad twice.
[
RA.GE
[ LOCK-OUT
HOLD 3 SECONDS
Range Lock-Out (onsomemodels)
Your c ontrolwi// allowyoutolockout thesurface
burners, o venburners andcontrol p anelsothey
cannot be activated
To lock/mflock tile controls:
[]
[]
[]
Tm'n all surlhce 1)urnets off.
Touch and hold the RANGE
LOCK-OUTpad f'o_ 3 seconds tmfil
tile displa) shows LOC ON.
To lmh)ck the control, touch and
hold the RANGE LOCK-OUTpad for
3 seconds tmtil the display shows
LOC OFF.
When this teatm'e
is on and tile touch
pads are touched, the control will beep
and tile display will show LOC ON.
Thecontrol lock-out mode affects all controls.
No controls wi// work when this feature is
activated
Theadjustment wi// be retained in memory
after a power failure.
13