GE P2S975 Installation Instructions Manual

Installation
Instructions
Self-Cleaning Dual Fuel
Slide-In Range _p2s975
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or Visit our Website at: www.GEAppliances.ca
IN THE COMMONWEALTH OF
MASSACHUSETTS:
® This product must be installed by
a licensed plumber or gas fitter.
¢ When using ball-type gas shut-off valves,
they shall be the T-handle type.
° A flexible gas connector, when used,
must not exceed 3 feet.
PNA te
fi + All ranges can tip.
+ BURNS or other SERIOUS Coo j
INJURIES can result, a bey
+ INSTALL and CHECK the "
ANTI-TIP bracket followi p e
the instructions supplied Anti-Tip Bracket
with the bracket. Kit Included
If you did not receive an anti-tip bracket with your
urchase, call 1.800.626.8774 to receive one at no cost.
in Canada, call 1.800.561.3344.)
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
® IMPORTANT — Save these
instructions for local inspector's use.
* IMPORTANT — observe all
governing codes and ordinances.
e Note to Installer - Be sure to leave these
instructions with the Consumer.
¢ Note to Consumer — Keep these
instructions for future reference.
e Product failure due to improper installation
is not covered under the Warranty.
AWARNING — This appliance must
be properly grounded.
® Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
AWARNING — Before beginning
the installation, switch power off at service
panel and lock the service disconnecting means
to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten
a prominent warning device, such as a tag,
to the service panel.
For installation instructions of the bracket, visit:
GEAppliances.com. (In Canada, www.GEAppliances.ca.)
PARTS INCLUDED
Rear Filler LAG
'Se
2 Screws Screws
Cp ora
O@od
Joint Sealant Pipe Fittings Shut Off Valve
wily
Lag Bolts Anchor Sleeves
(For Concrete Floors Only)
CSA-Approved Flexible Gas Line
3/8" Min. ID, 1/2" NPT Connection,
3-foot Maximum Length (Massachusetts only)
TOOLS YOU WILL NEED
31-10641-3 03-09 JR
Printed in the United States
* 1/4" Nut Driver * Level * Pipe Wrench
* Tape Measure * Drill * Safety Glasses
* Phillips Head * Flat Head « Wrench or Pliers
Screwdriver Screwdriver (for 17/16" Nut)