Television Operation; When Other Panasonic Products Respond To This Remote Control - Panasonic Diga DMR-EH50 Operating Instructions Manual

You c an configure the remote control TVoperation buttons toturn
the television on/off, change the television input mode, select the
television channel and change the television volume.
Point the remote control at the television
While pressing
[_ TV], enter the
code with the numbered buttons.
e.g., 01: [0] = [1] 10: [1] = [0]
Manufacturer and Code No.
Panasonic
AKAI
BRANDT
CURTIS
DUAL
FERGUSON
GOODMANS
HITACHI
IRRADIO
JVC
METZ
MIVAR
2
01/02/03/04/
45
27/30
10/15
31
05/06
10
05/06/31
NOKIA 25/26/27
ORION 37
i PHONOLA 31/33
PYE 05/06
SABA 10
SAMSUNG 31/32/43
SANYO 21
22/23/31/40/
41/42
30
17/39
28/31
24
SCHNEIDER 05/06/29/
30/31
SHARP 18
SINUDYNE 05/06/33
TELEFUNKEN 10/11/12/
13/14
TOSHIBA 16
_i_
Test by turning on the television and
changing channels.
• Repeat the procedure until you find the code that allows
correct operation.
• If your television brand is not listed or if the code listed for
your television does not allow control of your television, this
remote control is not compatible with your television.
=If your television brand has more than one code listed, select the
one that allows correct operation.
Change the remote control code on the main unit and the remote
control (the two must match) if you place other Panasonic products
close together.
Use "DVD 1", the factory set code, under normal circumstances.
While stopped
Press [FUNCTIONS].
2
Press [&, ,] to select "To Others"
and press [ENTER].
3
Press [&, T] to select "SETUP" and
press [ENTER].
4
Press [&, T] to select "Others" and
press [1_].
5 Press [&, T] to select "Remote
Control" and press [ENTER].
6
Press [&, T] to select the code
("DVD 1", "DVD 2" or "DVD 3") and
press [ENTER].
7
8
To change the code on the remote control
While pressing [ENTER], press and
hold the numbered button ([1], [2] or
[3]) for more than 2 seconds.
Press [ENTER].
• When the following indicator appears on the
unit's display
The unit's remote
control code
Change the code on the remote control to match the main unit's
(= step 7).
Executing "Shipping Condition" in the SETUP menu returns the
main unit code to "DVD 1". Change the remote control code to 1
(= step 7).
To return to the previous screen
Press [RETURN].
To exit the screen
Press [RETURN] several times.