Show Boot System - Dell PowerEdge M I/O Aggregator Reference Manual

show boot system

Syntax
Parameters
30 | File Management
Figure 4-7. restore factory-defaults (NvRAM only, all units in a stack) Command
Example
FTOS#restore factory-defaults stack-unit all nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing
* persistent settings (stacking, fanout, etc.)
* All the units in the stack will be split into standalone units.
* After restoration the unit(s) will be powercycled immediately.
* Proceed with caution !
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success
1 Success
2 Success
3 Not present
4 Not present
5 Not present
Power-cycling the unit(s).
FTOS#
Figure 4-8. restore factory-defaults (NvRAM only, single unit in a stack) Command
Example
FTOS#restore factory-defaults stack-unit 1nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing
* persistent settings (stacking, fanout, etc.)
* After restoration the unit(s) will be powercycled immediately.
* Proceed with caution !
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
1Success
Power-cycling the unit(s).
FTOS#
Displays information about boot images currently configured on the system.
show boot system stack-unit {0-5 | all}
0-5
Enter this information to display the boot image information of only the entered stack-unit
all
Enter this keyword to display the boot image information of all the stack-units in the stack
*
*
*
*
*
*
*
*
*