Protocol Lldp Mode - Dell PowerEdge M I/O Aggregator Reference Manual
Dell poweredge ftos command line reference guide for the m i/o aggregator
Hide thumbs
Also See for PowerEdge M I/O Aggregator:
- Getting started manual (38 pages) ,
- Command reference manual (290 pages)
Table of Contents
Advertisement
PROTOCOL LLDP Mode
20
|
CLI Basics
While in CONFIGURATION mode, use the protocol lldp command to enter PROTOCOL LLDP
mode. Use this mode to configure the LLDP protocol.
To enter MONITOR SESSION mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the protocol lldp command. You must enter the monitor session id. The prompt changes to
include (conf-lldp).
You can return to CONFIGURATION mode using the exit command.
Advertisement
Table of Contents
