Logging Coredump Server - Dell PowerEdge M I/O Aggregator Reference Manual

logging coredump server

Designate a server to upload core dumps.
Syntax logging coredump server {ipv4-address} username name password [type] password
Parameters
{ipv4-address}
name
type
password
Defaults Crash kernel files are uploaded to flash by default.
Command Modes
CONFIGURATION
Command
Version 8.3.17.0
History
Usage
Because flash space may be limited, using this command ensures your entire crash kernel files are
Information
uploaded successfully and completely. Only a single coredump server can be configured.
Configuration of a new coredump server over-writes any previously configured server.
Related
logging coredump stack-unit
Commands
logging coredump stack-unit
Enable the coredump.
Syntax logging coredump stack-unit all
Command Modes CONFIGURATION
Command
Version 8.3.17.0
History
Usage
The Kernel core dump can be large and may take up to five to 30 minutes to upload. FTOS does not
Information
overwrite application core dumps so delete them as necessary to conserve space on the flash; if the
flash is out of memory, the coredump is aborted. FTOS completes the coredump process and waits
until the upload is complete before rebooting the system.
Related
logging coredump server
Commands
Enter the server IPv4 address (A.B.C.D)
Enter a username to access the target server.
Enter the password type:
•
•
Enter a password to access the target server.
Supported on M I/O Aggregator
Note:
You must disable logging coredump stack-unit
destination for your core dumps.
Enable the kernel coredump
Supported on M I/O Aggregator
Enter 0 to enter an unencrypted password.
Enter 7 to enter a password that has already been encrypted using a Type
7 hashing algorithm.
Designates a sever to upload kernel core-dumps.
before you designate a new server
File Management | 27