Verifying Dcb Configuration - Dell PowerEdge M IO Aggregator Command Reference Manual

Verifying DCB Configuration

Use the show commands in
Table 6-2. Displaying DCB Configurations
Command
show dcb [stack-unit unit-number]
show interface port-type slot/port pfc statistics
(Figure 6-9)
show interface port-type slot/port pfc {summary
| detail} (Figure 6-10)
show interface port-type slot/port ets {summary
| detail} (Figure 6-11
Figure 6-8. show dcb Command Example
FTOS# show dcb
stack-unit 0 port-set 0
DCB Status :
PFC Port Count :
PFC Queue Count :
Figure 6-9. show interface pfc statistics Command Example
FTOS#show interfaces
Interface TenGigabitEthernet 0/3
Priority
-------------------------------------------------------------------------------
0
1
2
3
4
5
6
7
70 | Data Center Bridging (DCB)
Table 6-2
(Figure 6-8) Displays data center bridging status, number of PFC-enabled ports, and
and Figure 6-12)
Enabled
56 (current), 56 (configured)
2 (current), 2
tengigabitethernet 0/3 pfc
Rx XOFF Frames
0
0
0
0
0
0
0
0
to display DCB configurations and statistics.
Output
number of PFC-enabled queues. On the master switch in a stack, you can
specify a stack-unit number. Valid values: 0 to 5.
Displays counters for the PFC frames received and transmitted (by dot1p
priority class) on an interface.
Displays the PFC configuration applied to ingress traffic on an interface,
including priorities and link delay.
To clear PFC TLV counters on all ports or a specified port, use the
unit-number
counters {stack-unit
Displays the ETS configuration applied to egress traffic on an interface,
including priority groups with priorities and bandwidth allocation.
To clear ETS TLV counters on all ports or a specified port, enter the
unit-number command.
ets counters stack-unit
(configured)
statistics
Rx Total Frames
0
0
0
0
0
0
0
0
slot/port
| tengigabitethernet
Tx Total Frames
0
0
0
0
0
0
0
0
clear pfc
command.
}
clear