Using A Pre-Defined Buffer Profile - Dell PowerEdge M IO Aggregator Command Reference Manual

Mxl 10/40gbe switch io module ftos command reference guide, ftos 8.3.16.1
Hide thumbs Also See for PowerEdge M IO Aggregator:
Table of Contents

Advertisement

Using a Pre-Defined Buffer Profile

FTOS provides two pre-defined buffer profiles, one for single-queue (for example, non-QoS) applications,
and one for four-queue (for example, QoS) applications.
Task
Apply one of two pre-defined buffer profiles for all port
pipes in the system.
You must reload the system for the global buffer profile to take effect
Message 3 Reload After Applying Global Buffer Profile
% Info: For the global pre-defined buffer profile to take effect, please save the config and reload the
system.
FTOS Behavior: After you configure
bootup. Only one reboot is required for the configuration to take effect; afterwards this bootup
message may be ignored.
FTOS Behavior: The buffer profile does not returned to the default,
running-config to the startup-config, and then delete the startup-config and reload the chassis. The
only way to return to the default buffer profile is to explicitly configure
The
buffer-profile global
Message 4 Global Buffer Profile Error
% Error: User-defined buffer profile already applied. Failed to apply global pre-defined buffer profile.
Please remove all user-defined buffer profiles.
Similarly, when you configure
interface.
Message 5 Global Buffer Profile Error
% Error: Global pre-defined buffer profile already applied. Failed to apply user-defined buffer profile
on interface Tengig 0/1. Please remove global pre-defined buffer profile.
If the default buffer profile (4Q) is active, FTOS displays an error message instructing you to remove the
default configuration using the
262
|
Debugging and Diagnostics
Command
buffer-profile global [1Q|4Q]
buffer-profile global 1Q
command fails if you have already applied a custom buffer profile on an interface.
buffer-profile global
no buffer-profile global
(Message
,
Message 3
4Q
, you cannot not apply a buffer profile on any single
command.
Mode
CONFIGURATION
3).
is displayed during every
. If you configure
, save the
1Q
, and then reload the chassis.
4Q

Advertisement

Table of Contents
loading

Table of Contents