Configuring A Static Route For A Management Interface - Dell PowerEdge M IO Aggregator Command Reference Manual

Configuring a Static Route for a Management Interface

When an IP address used by a protocol and a static management route exists for the same prefix, the
protocol route takes precedence over the static management route.
To configure a static route for the management port, use the following command in CONFIGURATION
mode:
Command Syntax
management route ip-address mask
{forwarding-router-address
ManagementEthernet slot/port}
To view the configured static routes for the management port, use the
in EXEC privilege mode
Figure 10-6. show ip management-route Command Example
FTOS#show ip management-route all
Destination
-----------
1.1.1.0/24
172.16.1.0/24
172.31.1.0/24
FTOS#
Command Mode
CONFIGURATION
|
(Figure 10-6).
Gateway
-------
172.31.1.250
172.31.1.250
ManagementEthernet 1/0
Purpose
Assign a static route to point to the management
interface or forwarding router.
show ip management-route
State
-----
Active
Active
Connected
command
Interfaces | 125