Dell PowerEdge M IO Aggregator Command Reference Manual page 63

Figure 5-5. Recovering from a Failed Start: Example
U-Boot 2010.03-rc1(Dell Force10)
Built by build at tools-sjc-01 on Thu May 31 23:53:38 2012
IOM Boot Label 4.0.1.0
DRAM: 2 GB
Initialized CPLD on CS3
Detected [XLP308 (Lite+)
Initializing I2C0: speed = 30 KHz, prescaler = 0x0377 -- done.
Initializing I2C1: speed = 100 KHz, prescaler = 0x0109 -- done.
Initialized eMMC Host Controller
Detected SD Card
Now running in RAM - U-Boot [N64 ABI, Big-Endian] at: ffffffff8c100000
Flash: 256 MB
PCIE (B0:D01:F0) : Link up.
PCIE (B0:D01:F1) : No Link.
In: serial
Out: serial
Err: serial
Net: nae-0: PHY is Broadcom BCM54616S
IOM MAC Addr: 00:1E:C9:F1:00:99
Hit any key to stop autoboot:
***** Welcome to Dell Force10 Boot Interface *****
Use "help" or "?" for more information.
BOOT_USER #
BOOT_USER # boot change primary
'-' = go to previous field;
boot device
file name
Server IP address
BOOT_USER #
BOOT_USER # interface management ethernet ip address
Management ethernet IP address: 10.16.130.149/16
BOOT_USER #
BOOT_USER # default-gateway 10.16.130.254
Gateway IP address 10.16.130.254
BOOT_USER #
BOOT_USER # reload
NetLogic XLP Stage 1 Loader
Built by build at tools-sjc-01 on Thu May 31 23:53:38 2012
IOM Boot Selector Label 4.0.0.0
Rev A0]
0
'.' = clear non-essential field
: tftp
: IOA
: 10.16.127.34
10.16.130.149/16
Aggregator Management | 49