Sharp Notevision PG-M25X Operation Manual page 71

DHCP server function
■ What is a DHCP server function?
The DHCP server function automatically assigns IP addresses to devices connected to the network. When
the Network Settings on the computer have been set to Automatically get IP address (DHCP server enabled),
the projector will automatically assign IP addresses.
Make the following settings when using this function
1Set the DHCP server function on the projector to ON.
2Set the start value of the IP address assigned and an expected number of IP address to be automati-
cally assigned (Maximum number to be assigned).
For settings, see page
Note
• DHCP stands for Dynamic Host Configuration Protocol.
Wireless Channels
■ What is a wireless channel?
A wireless channel is a frequency used by wireless LAN PC cards when communicating. For IEEE802.11b
standard, 14 channels can be used. If other wireless LAN networks are being used near the location where
the projector is, make sure that different channels have been set to avoid interference.
■ Assigned wireless channels
If there are no other networks that can cause interference nearby, set either 1, 6, or 11.
If there are no interferences on 11 channel settings, you do not have to change the default settings.
For settings, see page
192.168.150.151
73.
11
71.
192.168.150.154
1
ch
6
ch
ch
-67