Glass Gasket; Door Glass; Pilot Adjustment - Regency Sunrise U32SE-NG5 Owners & Installation Manual

PILOT ADJUSTMENT

Periodically check the pilot fl ames. Correct
fl ame pattern has two strong blue fl ames: 1
fl owing around the fl ame sensor and 1 fl owing
across the burner (it does not have to be
touching the burner).
Burner
Flame Sensor
Pilot
Note: If you have an incorrect fl ame pattern,
contact your Regency
instructions.
Incorrect fl ame pattern will have small, probably
yellow fl ames, not coming into proper contact
with the rear burner or fl ame sensor.
U32SE-5 FPI Direct Vent Gas Insert
Conduct an inspection of the venting system semi-
annually. Recommended areas to inspect as follows:
1) Check the Venting System for corrosion in areas
that are exposed to the elements. These will
appear as rust spots or streaks, and in extreme
cases, holes. These components should be
replaced immediately.
2) Remove the Termination Cap, and shine a
fl ashlight down the Vent. Remove any bird
nests, or other foreign material.
Ignitor
3) Check for evidences of excessive condensation,
such as water droplets forming in the inner
liner, and subsequently dripping out the joints,
Continuous condensation can cause corrosion
®
dealer for further
of caps, pipe, and fi ttings. It may be caused
by having excessive lateral runs, too many
elbows, and exterior portions of the system
being exposed to cold weather.
4) Inspect joints, to verify that no pipe sections or
fi ttings have been disturbed, and consequently
loosened. Also check mechanical supports such
as Wall Straps, or plumbers' tape for rigidity.
If the glass gasket requires replacement use glass
gasket (Part # 936-155).
GENERAL VENT
MAINTENANCE

GLASS GASKET

MAINTENANCE

DOOR GLASS

Your FPI insert is supplied with high temperature,
5 mm Neoceram ceramic glass that will withstand
the highest heat that your unit will produce. If your
glass requires cleaning, we recommend using an
approved glass cleaner available at all authorized
dealers. Do not use abrasive materials. Do not
clean the glass when hot.
In the event that you break your glass by impact,
purchase your replacement from an authorized FPI
dealer only, and follow our step-by-step instructions
for replacement.
Warning: Do not operate appliance
with glass panels removed, cracked
or broken. Replacement of the glass
should be done by a licensed or
qualifi ed service person.
Caution: Wear gloves when removing damaged
or broken glass.
Flush Glass Replacement
Remove the fl ush door front (as per instructions in
section "Standard Flush Door"). Remove the 4 glass
clips from each corner. Slide in the new replacement
glass. Push the 4 glass clips back onto the frame.
35