Full Screen Front - FPI P36-NG3 Owners & Installation Manual

REGENCY OPTIONS
1) Before beginning the installation, remove the Screen Doors from the
Full Screen Door Frame by fully opening the doors and lifting up off
of the hinges. See important note in step 7.
2) Full Screen Door Frame Installation
a) Before attaching the Full Screen Door Frame to the unit, loosen the
3 x #8 Philips Head Screws located on the inside top of the outer frame
of the appliance. And remove the center screw.
Also loosen the #8 Philips Head Screw on the inner side of each hinge
bracket as shown below.
Inside Top
of Outer
Frame
Hinge
Bracket
Inner Hinge
Bracket Screw
b) Slide the cut-outs in the Top and Bottom Flange of the Full Screen Door
Frame under the screw heads which were loosened in step 2a.
Once the Frame is in place, tighten screws to secure.
52
FULL SCREEN FRONT INSTALLATION
Cut-Outs
Backside of Full
Screen Door
Frame Shown
Cut-Outs
NOTE: Should the finished wall protrude beyond the face of the unit,
you can accommodate up to 1/2" depth.
Simply push in the Full Screen Door Frame until it aligns against the
finished wall. Secure Top Flange of Full Screen Door Frame as
described in step 2.
For the Bottom Flange of the Full Screen Door Frame, push the bottom
of the Frame until it aligns with the wall. Use the inner cut-outs to
secure the base of the Frame using the 2 x Hex Head Drill Point
Screws provided.
Bottom
Flange
Inner
Cut-Outs
Backside of Full Screen
Door Frame Shown
FPI P36-3 Zero Clearance Direct Vent Gas Fireplace
Top
Flange
Bottom
Flange