Flush Trim; Louvers - Flush; Double Screen Door - FPI P36-NG3 Owners & Installation Manual

FLUSH TRIM

Attach the round magnets to the back of the top
trim piece and to the bottom trim piece, then
attach trim to the top and bottom of flush door.
FPI P36-3 Zero Clearance Direct Vent Gas Fireplace
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located un-
derneath the top of the firebox.
2) The bottom louver has a hinge that is at-
tached (2 screws per hinge) to the lip on
bottom of the unit.
Note: Top and
bottom louvers
are different.
3) Open the bottom louver. Pull the Burner ON/
OFF control box from inside the bottom of
the fireplace and position the slots in the
bracket over the 2 screws on the left side
of the bottom louver. Push down to lock into
place. Tighten the screws.
Burner ON/OFF
Screws on
control box
louver bracket
REGENCY OPTIONS
DOUBLE SCREEN
DOOR
1) Pull out the top louver.
2) Center the screen door and hook over the
flush door.
3) Open the screen door(s) and secure the
screen door to the flush door front with 2
clips on the bottom left and right side.
Clip locations
Clip installed on right side.
49