Bay Door; Bay Trim; Bay Louvers - FPI P36-NG3 Owners & Installation Manual

REGENCY OPTIONS

BAY DOOR

The Bay louvers MUST be used
with the Bay door option.
The optional Bay door is an overlay on the
flush front. The standard flush door and glass
must remain on the unit.
1) Hook the top of the bay door over the flush
door flange and swing the bottom against
the bottom flange of the flush door.
2) Secure to the flush door bottom bracket
with 2 screws provided.
3) Slide the valve extension knobs onto the
valve knobs.
Note: If any maintenance etc. must be
done in the firebox, first remove
the Bay louvers and door.
50

BAY TRIM

Attach 4 supplied magnets each to the back of
the top and bottom trim pieces, and attach trim
to the top and bottom of Bay door.

BAY LOUVERS

1) Install top louver by sliding the two bracket
clips into the brackets located on top of the
bay door. See below. The fitted louver
leaves a small gap between faceplate bot-
tom and louver top.
2) Install bottom louver by sliding the two
bracket clips into the brackets located un-
derneath the bay door. Secure with 1
screw into each Bottom Louver Mounting
Bracket as per diagram below. Use the
bottom hole in the bracket.
3) Slide the valve extension knobs onto the
valve knobs. Match the correct ext. knob
with the valve knob.
4) Open the bottom louver. Pull the Burner ON/
OFF control box from inside the bottom of
the fireplace and position the slots in the
bracket over the 2 screws on the left side
of the bottom louver. Push down to lock into
place. Tighten the screws.
Screws on
louver bracket
FPI P36-3 Zero Clearance Direct Vent Gas Fireplace
Burner ON/OFF
control box