Table of Contents
Advertisement
INSTALLATION
Diagram 4
Diagram 5
Diagram 5.
®
11) Push the Regency
logo plate into the
STANDARD
FLUSH DOOR
The standard fl ush door comes with a black
frame. To install the frame, simply hook the top
door fl ange onto the top of the unit and swing
the door towards the unit, diagram 1. Be careful
that the glass gasket does not roll up; there
must be a gap between the gasket and the door
lip to ensure that the door sits securely on the
unit. Diagram 2.
Diagram 1a
12
Use the hook to pull the spring out until you
can put the hook into the slot on the bottom
door bracket. Repeat for 2nd spring.
diagram 3.
To remove the fl ush door, reverse the above
steps.
NOTE: The chain must rest on TOP of the gas
inlet pipe never under it.
OPTIONAL
FLUSH TRIM
Attach 2 round magnets to the back of the top
trim piece and the other 2 to the bottom trim
piece, then attach trim to the top and bottom
of Flush door.
Diagram 1b
Diagram 2
See
Diagram 3
OPTIONAL DOUBLE
SCREEN DOORS
1) Pull out the top
louver.
2) C e n t e r t h e
screen door
and hook over
the fl ush door.
3) Open the screen door(s) and secure the
screen door to the fl ush door front with 2
clips on the bottom left and right side.
Clip locations
Clip installed
on right side.
FLUSH LOUVERS
1) The top louver is held in place by friction fi t,
if the louver needs to be adjusted; bend the
bracket out as shown in the diagram.
U32-4 FPI Direct Vent Gas Insert
Advertisement
Table of Contents
