Rigid Pipe Venting Systems - Regency P33-NG4 Owners & Installation Manual

INSTALLATION
The minimum components required for a basic
horizontal termination are:
1 AstroCap Horizontal Termination Cap
1 45 o Elbow
1 Rigid Pipe Adaptor
1 Wall Thimble
1 Length of pipe to suit wall thickness
(see chart)
For siding other than vinyl furring strips may be used,
instead of the vinyl siding standoff, to create a level
surface to mount the vent terminal. The Terminal
must not be recessed into siding.
If a Vinyl Siding Standoff is required (it must be
used with vinyl siding), measure to outside surface
of wall without siding and add 2 inches.
The FPI AstroCap TM and FPI Riser Vent terminal are certifi ed for installations using FPI venting systems as well as Simpson Dura-Vent
American Metal Products Ameri Vent Direct Vent, Security Secure Vent
Products International Ltd. Dura-Vent® and Direct Vent are registered and/or proprietary trademarks of Simpson Dura-Vent Co. Inc.
20

RIGID PIPE VENTING SYSTEMS

Horizontal or Vertical Terminations
Alternate
Horizontal
Termination
Caps
Flat Wall Installation
Max. Wall
Thickness (inches)
7 - 1/4"
10 - 1/4"
13 - 1/4"
12-1/4" - 15-7/8"
18-1/4" - 25-1/4"
Vent Length
Required (inches)
6"
9"
12"
11" - 14-5/8" Adj. Pipe
11" - 14-5/8" Adj. Pipe
®
, Selkirk Direct-Temp. AstroCap
Regency
WARNING:
Do not combine venting components from
different venting systems.
However use of the AstroCap TM
is acceptable with all systems.
This product has been evaluated by Intertek
for using a Rigid Pipe Adaptor in conjunction
with Duravent Direct-Vent , Selkirk Direct-Temp,
Ameri Vent Direct venting and Security Secure
Vent systems. Use of these systems with the
Rigid Pipe adaptor is deemed acceptable and
does not affect the Warnok Hersey/Intertek
listing of components.
When using Rigid Vent other than
Simpson Dura-Vent, 3 screws must be
used to secure rigid pipe to adaptor.
® Direct Vent Pro,
TM
is a proprietary trademark of FPI Fireplace
®
P33-4 Zero Clearance Direct Vent Gas Fireplace
and FPI Riser