Contemporary Faceplate Installation Part 1 - Regency P33-NG4 Owners & Installation Manual

CONTEMPORARY FACEPLATE INSTALLATION PART 1

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
1) Shut off the gas supply.
2) a) Open the fl ush door and remove the door (see p.37 in the P33-4 manual).
b) Remove the logs, embers, and brick panels (if used).
c) Remove the 2 screws holding the Burner Assembly to the fi rebox base.
Push the Burner Assembly to the left and lift out.
3) Remove burner orifi ce with a 1/2" wrench and discard. Use another wrench to hold on to the elbow behind the orifi ce.
4) Reinstall new burner orifi ce and tighten.
NG #47
*LP #56 (LP Conversion - Must also use Kit #434-969 with P33 units and Kit #425-972 with P33E units)
5) Reverse Steps 1 and 2.
Note: Place Decal Derating P33-4 (918-777) to decal plate by overlaying existing decal located on the front side base of the unit.
* For conversion from NG to LP refer to the NG to LP conversion section in the P33-4 manual.
®
Regency P33-4 Zero Clearance Direct Vent Gas Fireplace
(
DERATING TO LOWER BTU RATING)
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Remove the 2 screws, push Burner
Contemporary Faceplate Derating Kit Contains:
Qty. Part #
1
1
1
1
Assembly to the left and lift out.
INSTALLATION
Description
904-434 Burner Orifi ce #47 (Natural Gas)
904-241 Burner Orifi ce #56 (Propane Gas)
(NOTE: Must also use Kit #434-969 with
P33 units and Kit #425-972 with P33E unit
918-777 Decal Overlay
918-767 Instruction Sheet
Burner Orifi ce
43