Regency Horizon HZ42ST-NG Owners & Installation Manual page 36

11) Remove the 4 cover plates located in the lower outside front
and back of the fi rebox by removing 4 screws from each plate.
Discard the cover plates and gaskets - keep the screws.
Cover Plate
12) Remove one screw securing the socket end of the diffuser and
separate the 2 parts - as shown below.
13) Remove the amber glass - by sliding out.
14) Place gasket over the inside perimeter of the light diffuser box.
HZ42ST Regency Horizon TM Gas Fireplace
15) From outside the fi rebox -Install light assembly box and
gasket into opening created from the removal of the cover plates
open end up - as shown below.
16) Secure the light diffuser in place with the 4 screws set aside from
the cover plates.
17) Slide amber glass into light diffuser to reinstall.
18) Install bulb into socket end of assembly.
Note: Oils from hands will shorten the life of the bulbs,
do not handle bulbs with bare hands.
19) Install socket and bulb into light diffuser as shown below.
INSTALLATION
Screws secured from outside
the fi rebox.
35