Setting Up Dlc - Epson Stylus Color 800N Setup Manual

Caution:
Once you make changes
to the Ethernet card,
wait for at least five
minutes before turning
off or restarting your
printer.
3. Set the following options in the IP Config dialog box:
IP address
Determine and assign an IP address. Check with your
network administrator or see the note below for
information about assigning IP addresses.
Subnet mask
Assign the subnet mask. Check with your network
administrator or see the note below for information
about assigning subnet masks.
Auto IP address
Set to
Off.
4. After making your settings, click
After you configure your printer, you need to install EPSON
Status Monitor 2. See page 24 for instructions.
Note About IP Addresses and Subnet Masks
If you don't have a network administrator, you can assign IP
addresses in the range of 192.168.1.1 to 192.168.1.254. Each
computer or other device connected directly to the network
must have a unique IP number. The subnet mask should be
255.255.255.0. However, you should not use these addresses if
your network has a direct (rather than dial-up) connection to
the Internet.

Setting Up DLC

If you use Windows NT, the Ethernet card can work with the
DLC (Data Link Control) support provided in your operating
system. Follow the instructions below to install DLC support in
Windows and configure the printer.
19
Setup Guide
.
Save