Configuring The Ethernet Card In Windows Nt 3.5X - Epson Stylus Color 800N Setup Manual

Note:
If you want to share the
new printer, click Share
the Printer on the
Network. The share
name defaults to the
printer name; you can
change it if necessary.
For more information
about sharing, see your
Windows NT
documentation.
6. Type a name for the port in the
name is not the same as an existing port, such as LPT1.
7. Select the target node address from the
Make sure this address matches the one listed under Node
Number on the status sheet.
8. Click the
Timers
Then click
Close
9. Click , then follow the instructions on the screen for
Next
printer driver installation.
Configuring the Ethernet Card in Windows
NT 3.5x
After you have installed the DLC protocol, follow these steps to
configure the card and your printer for Windows NT 3.5x:
1. Double-click
Print Manager
2. Choose
Create Printer
Printer dialog box appears.
3. Type a name for the printer. Then select the printer driver
from the Driver menu. Select
menu. The Print Destinations dialog box appears.
4. Choose
Hewlett Packard Network Port
Available Print Destinations list.
5. Type a name for the port in the Name box. Make sure the
name is not the same as an existing port, such as LPT1.
6. Select
LAN Hardware Address (Node Address)
the Card Address list. This address matches the one listed
under Node Number on the status sheet.
7. Click the
Timer
option. Then click
box.
21
Name
button and select the
.
in the Main group.
from the Printer menu. The Create
from the Print To
Other
button and select the
Click again to exit the dialog
OK. OK
Setup Guide
box. Make sure the
list.
Card Address
option.
Job Based
from the
from
Job Oriented