Epson Stylus Color 800N Setup Manual page 17

Setup Guide
Caution:
Once you make changes
to the Ethernet card,
wait for at least five
minutes before turning
off or restarting your
printer.
6. Click at the bottom of the dialog box to assign a print
Add
queue to your print server.
The Add Queue dialog box appears:
7. For Print Server mode, select the file server where the print
queue will reside, then select a print queue from the list.
You can create a new queue by entering its name in the
Queue box. Then continue with step 8.
For Auto, assign the same print queues to the printer that
are assigned to the NetWare print server. Make any
additional configuration changes for either Print Server
mode or Remote Printer mode. Then click
your settings.
8. Select a priority level for the queue in the Priority box. You
can set a level from 1 to 10, with 1 having the highest
priority.
9. Click . The NetWare Config dialog box appears again.
OK
10. Repeat steps 6 through 8 if you want to add more print
queues to the print server. Click
Config dialog box to save your settings.
After you configure your printer, you need to install EPSON
Status Monitor 2. See page 24 for instructions.
14
This list indicates
which queues are
available on this
NetWare file server.
to save
Save
in the NetWare
Save