Installing Lpr Software In Windows Nt - Epson Stylus Color 800N Setup Manual

If you receive 4 lines that say "Request Timed Out," the
card is not set up correctly. Check to make sure the card is
on the same segment of the network as the workstation you
are using to configure it and that you typed in the correct
IP and hardware addresses.
Before you can print using TCP/IP, you still need to install the
Status Monitor (see page 24) and add a printer port (see
page 27).

Installing LPR Software in Windows NT

Follow these steps if you need to set up Windows NT to print
with TCP/IP:
1. Open the Control Panel.
2. Double-click the
3. In Windows NT 4.x, click the
TCP/IP Printing
skip to "Configuring the Ethernet Card for TCP/IP" on
page 18. If it is not, click
In Windows NT 3.5x, if
listed under Installed Network Software, you can skip to
"Configuring the Ethernet Card for TCP/IP" on page 18.
If it is not, click
4. In Windows NT 4.x, select
from the Network Service list and click
step 6.
In Windows NT 3.5x, select
s from the Network Software list and click
component
.
Continue
5. In Windows NT 3.5x, select
in the Windows NT TCP/IP Installation Options
Support
dialog box and click
17
icon.
Network
Services
is listed under Network Services, you can
.
Add
Microsoft TCP/IP Printing
.
Add Software
Microsoft TCP/IP Printing
TCP/IP Protocol and related
TCP/IP Network Printing
.
Continue
Setup Guide
tab. If
Microsoft
is
. Continue with
OK