Configuring For Tcp/Ip; Installing Tcp/Ip In Windows 95 - Epson Stylus Color 800N Setup Manual

Configuring for TCP/IP

You can configure the Ethernet card for TCP/IP if you are
using a UNIX TCP/IP network, a Windows 95 peer-to-peer
network, or Windows NT.

Installing TCP/IP in Windows 95

Windows 95 does not come with LPR, so in addition to
installing TCP/IP, as described below, you need to install the
EPSON TCP/IP printer protocol. The EPSON Status
Monitor 2 installer program automatically prompts you when
to install EPSON TCP/IP printer protocol.
Follow these steps to install TCP/IP:
1. Open the Control Panel.
2. Double-click the
3. If TCP/IP appears in the list of installed network
components on the Configuration screen, you can skip to
"Assigning the IP Address" on page 16. If TCP/IP does not
appear in the list, click
4. Click
Protocol
5. Select
Microsoft
from the Network Protocols list. Then click
6. Click again and follow any on-screen instructions to
OK
enable TCP/IP.
15
icon.
Network
.
Add
and then click the
Add
from the Manufacturers list and
Setup Guide
button.
TCP/IP
.
OK