Configuring For Tcp/Ip - Epson Stylus Color 850Ne Setup Manual

Setup Guide: Configure the Printer
Note:
If the Status Monitor 2
program is open, or if
background monitoring is
turned on, it may interfere
with EPSON Net!2. Close
Status Monitor 2 if it is
running and turn off
background monitoring,
following step 13 on
page 15.
7. Select
Printer Status
server. Then check the status.
8. Select
Queues serviced
which you set in step 5 on page 17 under "Using
NwAdmin to Set Up Your Printer" exists in the Print
Queues Serviced By Printer box.

Configuring for TCP/IP

For a Windows 98, Windows 95, or Windows NT network
with TCP/IP, you need to set the card's IP address. You can use
EPSON Net!2 or the arp command to do this, as described in
the sections below.
Windows 98 and Windows 95 do not come with the TCP/IP
printing protocol, so in addition to TCP/IP, you need to install
the EPSON TCP/IP Printing protocol included with Status
Monitor 2. See page 11 for instructions.
Using EPSON Net!2
Make sure the Ethernet card and printer are on the same
segment of the network as the computer you are using to
configure the card. Also, you need to know the IP address for
the computer and the IP address you will assign to the printer's
Ethernet card.
Follow these steps to assign an IP address:
1. Make sure Windows is running, the Ethernet card is
connected to the network, and the printer is turned on.
2. Click , point to
Start
then click
EPSON Net!2
28
from the Console screen of the print
. Check if the print queue name
, point to
Programs
.
,
EPSON Net!2