Kyocera TASKalfa 180 Operation Manual page 40

Preparation before Use
2-8
2
Adjust the paper width guides to the width of the
paper.
3
Insert the paper along the paper width guides into
the tray until it stops.
IMPORTANT: Keep the side that was closest the
package seal facing up.
Put only the paper on the MP tray.
Do not load more paper than the paper feed capacity of
the MP tray.
Curled paper must be uncurled before use.
Straighten the top edge if it is curled.
When loading paper into the multi purpose tray, check
that there is no paper left over in the tray from a previous
job before loading the paper. If there is just a small
amount of paper left over in the MP tray and you want
to add more, first remove the left-over paper from the
tray and include it with the new paper before loading the
paper back into the tray.
NOTE:
When loading paper into the multi purpose
tray, set it with the side to be printed facing down.
OPERATION GUIDE