Setting Up Fc-Fc Routing; Verifying The Setup For Fc-Fc Routing - HP SN3000B Administrator's Manual

Brocade fabric os administrator's guide - supporting fabric os v7.0.1 (53-1002446-01, march 2012)
Hide thumbs Also See for SN3000B:
Table of Contents

Advertisement

1. Connect to the FC router and log in using an account with admin permissions.
2. Enter the fcrXlateConfig
3. Enter the fcrXlateConfig
Example

Setting up FC-FC routing

To set up FC-FC routing, perform the following tasks in the order listed.
1. Verify that you have the proper setup for FC-FC routing. (Refer to
2. Assign backbone fabric IDs. (Refer to
3. Configure FCIP tunnels if you are connecting Fibre Channel SANs over IP-based networks.
4. Configure IFLs for edge and backbone fabric connection. (Refer to
5. Modify port cost for EX_Ports, if you want to change from the default settings. (Refer to
6. Configure trunking on EX_Ports that are connected to the same edge fabric. (Refer to
7.
Refer to
configuration options for Brocade Backbones.

Verifying the setup for FC-FC routing

Before configuring a fabric to connect to another fabric, you must perform the following verification
checks on the FC router.
1. Log in to the switch or Backbone as admin and enter the version command. Verify that
Fabric OS Administrator's Guide
53-1002446-01
sw0:root> fcrxlateconfig --show stalexd
Imported FID
Stale XD
--------------------------------------------------
012
002
sw0:root> fcrxlateconfig --del stalexd 12 2
Xlate domain 2 is deleted
routing"
on page 475.)
(Refer to
"FCIP tunnel configuration"
configuration"
on page 478.)
router port cost configuration"
frame trunking configuration"
Configure LSAN zones to enable communication between devices in different fabrics. (Refer to
"LSAN zone configuration"
Chapter 3, "Performing Advanced Configuration Tasks,"
Fabric OS v7.0.1 is installed on the FC router as shown in the following example.
switch:admin> version
Kernel:
2.6.14.2
Fabric OS:
v7.0.1
Made on:
Fri Nov 18 01:15:34 2011
Flash:
Mon Nov 21 20:53:48 2011
BootProm:
1.0.9
show command to identify any stale xlate domains.
--
del command to delete the stale xlate domains.
--
Owner Domain
007 ( this FCR )
"Backbone fabric IDs"
on page 478.)
on page 482.)
on page 484.)
on page 485.)
Setting up FC-FC routing
"Verifying the setup for FC-FC
on page 477.)
"Inter-fabric link
for more details about
24
"FC
"EX_Port
475

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os v7.0.1

Table of Contents