Restrictions - HP SN3000B Administrator's Manual

8
Configuration file restoration
CAUTION
Make sure that the configuration file you are downloading is compatible with your switch model.
Downloading a configuration file from a different switch model or from a different firmware could
cause your switch to fail.
CAUTION
If you have Virtual Fabrics enabled, you must follow the procedure in
for Virtual Fabrics"
If a configDownload command is issued on a non-FC router, any FC router parameters may be
viewed in the downloaded data. This is harmless to the switch and can be ignored.
Note that while is possible to transfer a v6.4.1 config file to a v7.0.0 switch, the reverse cannot be
done. You cannot transfer a v7.0.0 config file to a v6.4.1 switch.

Restrictions

-chassis
-fid FID
-fid FID -sfid FID The FID must be defined on the switch and the source FID must be defined in the
182
on page 186 to restore the logical switches.
The number of switches defined in the downloaded configuration file must
match the number of switches currently defined on the switch.
The FID must be defined in both the downloaded configuration file and the
current system.
NOTE
Brocade recommends you disable a switch before downloading a configuration
file. If you plan to download a configuration file while the switch is enabled, see
"Configuration download without disabling a switch"
downloaded configuration file.
"Configuration management
on page 184.
Fabric OS Administrator's Guide
53-1002446-01