Configuring Compression; Disabling Encryption - HP SN3000B Administrator's Manual

14
Configuring encryption and compression

Configuring compression

NOTE
Before performing this procedure, it is recommended that you check for port availability using the
portEncCompShow command. See
page 313 for details.
To configure compression on a port, follow these steps:
1. Connect to the switch and log in using an account with admin permissions, or an account with
2. Disable the port on which you want to configure compression. Use the portDisable command.
3. Enter the portCfgCompress
4. Enable the port with the portEnable command.
After enabling the port, the new configuration becomes active.

Disabling encryption

To disable encryption on a port, follow these steps:
1. Connect to the switch and log in using an account with secure admin permissions, or an
2. Disable the port on which you want to disable encryption. Use the portDisable command.
3. Enter the portCfgEncrypt
4. Enable the port with the portEnable command.
After enabling the port, the new configuration becomes active.
316
OM permissions for the SwitchPortConfiguration RBAC class of commands.
This example enables compression on port 21 on a Brocade 6510 switch:
portcfgcompress --enable 21
This example enables compression on port 15 of an FC16-32 blade in slot 9 of an enterprise
class platform:
portcfgcompress --enable 9/15
account with OM permissions for the EncryptionConfiguration RBAC class of commands.
This example disables encryption on port 21 on a Brocade 6510 switch:
portcfgencrypt --disable 21
This example disables encryption on port 15 of an FC16-32 blade in slot 9 of an enterprise
class platform:
portcfgencrypt --disable 9/15
"Viewing the encryption and compression configuration"
enable command.
--
disable command.
--
on
Fabric OS Administrator's Guide
53-1002446-01