Changing The State Of A Ti Zone - HP SN3000B Administrator's Manual

4. Enter the cfgEnable command to reactivate your current effective configuration and enforce
Example of modifying a TI zone
To add port members to the existing TI zone bluezone:
To add port members to the existing TI zone in a backbone fabric:
To disable failover on the existing TI zone bluezone:
To enable failover and add ports to TI zone greenzone:
To remove ports from the TI zone bluezone:
Remember that your changes are not enforced until you enter the cfgEnable command.

Changing the state of a TI zone

You can change the state of a TI zone to activated or deactivated. Changing the state does not
activate or deactivate the zone. After you change the state of the TI zone, you must enable the
current effective configuration to enforce the change.
The TI zone must exist before you can change its state.
1. Connect to the switch and log in using an account with admin permissions.
2. Perform one of the following actions:
3. Enter the cfgEnable command to reactivate your current effective configuration and enforce
Fabric OS Administrator's Guide
53-1002446-01
c. Reset the failover option to failover disabled. Then continue with
zone --add -o n name
the TI zones.
cfgenable "current_effective_configuration"
switch:admin> zone --add bluezone -p "3,4; 3,6"
switch:admin> zone --add backbonezone -p "3,4; 3,6; 10:00:00:04:1f:03:16:f2;"
switch:admin> zone --add -o n bluezone
switch:admin> zone --add -o f greenzone -p "3,4"
switch:admin> zone --remove bluezone -p "3,4; 3,6"
•
To activate a TI zone, enter the zone
zone --activate name
•
To deactivate a TI zone, enter the zone
zone --deactivate name
the TI zones.
cfgenable "current_effective_configuration"

Changing the state of a TI zone

activate command.
--
deactivate command.
--
12
step 4.
289