Routing Policies; Displaying The Current Routing Policy - HP SN3000B Administrator's Manual

Brocade fabric os administrator's guide - supporting fabric os v7.0.1 (53-1002446-01, march 2012)
Hide thumbs Also See for SN3000B:
Table of Contents

Advertisement

4

Routing policies

Example of enabling a gateway link on slot 2, port 3

Routing policies

By default, all routing protocols place their routes into a routing table. You can control the routes
that a protocol places into each table and the routes from that table that the protocol advertises by
defining one or more routing policies and then applying them to the specific routing protocol.
The routing policy is responsible for selecting a route based on one of two user-selected routing
policies:
On the Brocade 300, 5100, 5300, 5410, 5450, 5460, 5470, 5480, 6505, 6510, 7800, 8000, and
VA-40FC switches, Brocade DCX and DCX 8510 Backbone families, routing is handled by the FSPF
protocol and either the port-based routing or exchange-based routing policy.
Each switch can have its own routing policy and different policies can exist in the same fabric.
ATTENTION
For most configurations, the default routing policy is optimal and provides the best performance. You
should change the routing policy only if there is a performance issue that is of concern, or if a
particular fabric configuration or application requires it.

Displaying the current routing policy

1. Connect to the switch and log in using an account with admin permissions.
2. Enter the aptPolicy command with no parameters.
Example of the output from the aptPolicy command
70
ecp:admin> portcfgislmode 2/3, 1
Committing configuration...done.
ISL R_RDY Mode is enabled for port 3. Please make sure the PID
formats are consistent across the entire fabric.
Port-based routing
Exchange-based routing
The current policy is displayed, followed by the supported policies for the switch.
In the following example, the current policy is exchange-based routing (3) with the additional
AP dedicated link policy.
switch:admin> aptpolicy
Current Policy: 3 1(ap)
3 0(ap): Default Policy
1: Port Based Routing Policy
3: Exchange Based Routing Policy
0: AP Shared Link Policy
1: AP Dedicated Link Policy
Fabric OS Administrator's Guide
53-1002446-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os v7.0.1

Table of Contents