HP SN3000B Administrator's Manual page 357

Next, you enable encryption on port 0. Note that the first attempt fails because the port is currently
enabled. This example uses the portCfgShow command to check the result. Notice that the output
shows encryption to be enabled on the port.
Fabric OS Administrator's Guide
53-1002446-01
2. Peer secret: The secret of the peer that authenticates to peer.
3. Local secret: The local secret that authenticates peer.
Press enter to start setting up secrets >1
Enter peer WWN, Domain, or switch name (Leave blank when done):
10:00:00:05:1e:e5:cb:00
Enter peer secret:
Re-enter peer secret:
Enter local secret:
Re-enter local secret:
Enter peer WWN, Domain, or switch name (Leave blank when done):
Are you done? (yes, y, no, n): [no] y
Saving data to key store... Done.
myswitch:root> secauthsecret --show
WWN
-----------------------------------------------
10:00:00:05:1e:e5:cb:00
myswitch:root>
myswitch:root> portcfgencrypt --enable 0
Please disable port to configure Encryption/Compression.
myswitch:root> portdisable 0
myswitch:root> portcfgencrypt --enable 0
Turning ON Encryption on port(246) will cause the port to be disabled during
next LOGIN
myswitch:root> portenable 0
myswitch:root> portcfgshow 0
Area Number:
Octet Speed Combo:
Speed Level:
AL_PA Offset 13:
Trunk Port
Long Distance
VC Link Init
Locked L_Port
Locked G_Port
Disabled E_Port
Locked E_Port
ISL R_RDY Mode
RSCN Suppressed
Persistent Disable
LOS TOV enable
NPIV capability
QOS E_Port
Port Auto Disable:
Rate Limit
EX Port
Mirror Port
Credit Recovery
F_Port Buffers
Fault Delay:
NPIV PP Limit:
CSCTL mode:
Encryption and compression example
DId Name
150 dcx_150
0
3(16G,10G)
AUTO(SW)
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
AE
OFF
OFF
OFF
OFF
ON
OFF
0(R_A_TOV)
126
OFF
14
319