2.8.6 Slave Mode
(1) Ensure that the board is connected to the fieldbus. Then, start the applicomIO
(2) Select Description | Properties.
(3) Select the "Profibus, Slave" in the Cannel Properties dialog and click the OK
NOTE
(4) Click on the "Protocol list" under the board that was just added.
(5) Select Protocol | Properties.
Fieldbus I/O Rev.6
console application.
button.
Though you can select the "Profibus, Master/Slave" as a slave, it might not
communicate properly in some Master.
To use only the slave function, select the "Profibus, Slave".
2. Installation
51