2. Installation
2.7 DeviceNet Board Installation
Following two types can be used for the fieldbus I/O option DeviceNet.
- PCU-DVNIO
- PCI-DVNIO
2.7.1 Board Appearance
Part names and functions of the scanner board are shown in the following figure.
For details of the status display LEDs (Module/NetWork LED and IO LED), refer to the 4.
Troubleshooting in this manual.
PCU-DVNIO
(Do not use this port.)
PCI-DVNIO
(Do not use this port.)
Port for Board Configuration
Left: Module/NetWork LED
Right: IO LED
26
4-pin Terminal
Watchdog Port
Status Display LED (2)
DeviceNet Port
LED (2)
(Not in use)
RJ45 Connector
(Not in use)
4-pin Terminal
Watchdog Port
Male 9-pin D-Sub
Status Display LED (2)
DeviceNet Port
Jumper for Board Address
JP1
0
1
Jumper for Board Address
JP1
Fieldbus I/O Rev.6
JP1
C0 C1 C2
JP1
0
1
C0 C1 C2