Gateway E-9722R User Manual page 74

Beeps
1
2
3
4
5
6
7
8
9
10
11
68
CHAPTER 6: Troubleshooting
Description
Memory refresh timer error
Parity error in the first 64 KB of memory.
Base memory read/write test error
System board timer not operational.
A processor on the system board generated an
error.
The keyboard controller (8042) may be
defective. The BIOS cannot switch to Protected
mode.
General exception error (processor exception
error).
Display memory error (system video adapter).
The ROM checksum value does not match the
value encoded in the BIOS.
The shutdown register for CMOS RAM failed.
The cache memory test failed.
Troubleshooting steps
Reseat the memory modules or replace with
modules you know are good.
Same as for 1 beep.
Same as for 1 beep.
Possible system board malfunction. To eliminate
the possibility of an add-in card problem,
remove all expansion cards.
If the beep code occurs even when all expansion
cards have been removed, the system board is
at fault.
If the beep code does not occur when the
expansion cards have been removed, one of the
cards is causing the problem. Install the cards
one at a time until the problem happens again.
When the beep code returns, the most recent
card you installed is at fault.
Remove one of the processors if two are
installed, then try a known good processor in
the first socket.
Same as for 4 beeps.
Remove the keyboard to see if the error goes
away. If it does, try a known good keyboard.
Same as for 4 beeps.
Same as for 5 beeps
If the system video adapter is an add-in card,
replace or reseat the video adapter. If the video
adapter is integrated into the system board, the
board may be faulty. Try using an add-in card.
Same as for 4 beeps.
Same as for 4 beeps.
Same as for 4 beeps.