Preparing To Install Components; Selecting A Place To Work; Gathering The Tools You Need; Getting Help - Gateway E-9722R User Manual

Preparing to install components

Selecting a place to work

Work on your server in an area that:
•
•
•
•
•
•

Gathering the tools you need

Some tools and supplies that you may need to work on your server are:
•
•
•
•
•

Getting Help

If you have questions about performing any of these procedures, contact Gateway Customer
Care. For more information, see

Preventing static electricity discharge

server and unplug the power cords and modem cable before opening the server case.
The components inside your server are extremely sensitive to static electricity, also known as
electrostatic discharge (ESD).
server. Prevent ESD damage by following ESD guidelines every time you open the server
case.
Before working with server components, follow these guidelines:
•
•
•
24
CHAPTER 4: Installing Components
Is clean (avoid dusty areas).
Is a low-static environment (avoid carpeted areas).
Has a stable surface on which to set your server.
Has enough room to place all of your server parts.
Is near a grounded outlet so you can test your server after installation.
Is near a telephone (in case you need help from Gateway Customer Care). The telephone
must be directly connected to a telephone jack and cannot be connected to your server.
Tip
Blue latches, thumbscrews, or connectors indicate tool-less components.
Green latches and connectors indicate hot-swappable components.
A notebook to take notes
A Phillips screwdriver
A small flat-blade screwdriver
Small containers to store various types of screws
A grounding wrist strap (available at most electronic stores)
Warning
To avoid exposure to dangerous electrical voltages and moving parts, turn off your
Caution
ESD can permanently damage electrostatic discharge-sensitive components in the
Turn off the server, then unplug the power cords and all other cables.
Important
If you are replacing a hot-swappable system fan, you do not need to turn
off the server or unplug the power cord(s) and other cables.
Press the power button to drain any residual power from the server.
Wear a grounding wrist strap (available at most electronics stores) and attach it to a bare
metal part of the server. You can also touch a bare metal surface on the back of the server
with your finger.
"Getting Help" on page 9.