Gateway E-9722R User Manual page 43

9
Press the tab (8) holding the riser card in the riser card assembly, then push the riser card
in the direction shown (9) to unlock and remove it from the standoffs.
10
Insert the new riser card into the riser card assembly, then push it toward the back of the
assembly. It should snap into place.
11
Insert the new PCI card into the riser card, making sure any connectors extend through
the slot at the back of the assembly and that the card is fully seated in the riser card.
12
Close the release lever (see
13
Position the PCI riser card assembly (1) over the PCI socket on the server board, then press
the PCI riser card assembly into the PCI socket until it clicks into place.
14
Follow the instructions in
15
See the card's documentation for software installation instructions.
www.gateway.com
Standoff
Step 6) and the card guide tab.
"Closing the server case" on page 27.
37