Replacing The Power Distribution Module - Gateway E-9722R User Manual

3
4
5
6

Replacing the power distribution module

To replace the RPS power distribution module:
1
2
3
4
5
44
CHAPTER 4: Installing Components
Press the retaining clip (1) on the power supply to the left to release the power supply
module (2) from the chassis.
Using the handle, pull the power supply module straight out of the server. It may take
considerable force to remove.
Push the new power supply module into the server, with the retaining clip on the right,
until it locks into place.
Reconnect the AC power cord for the new power supply module.
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Remove the PCI riser assembly by following the instructions in
PCI expansion cards" on page
Remove the fan duct and system fan cage by following the instructions in
system fans" on page 38.
Disconnect the main power, CPU power, backplane power, I
cables from the system board. See
connectors on the system board.
"Preventing static electricity discharge" on page
"Opening the server case" on page
34.
"System board" on page 5
24. Make sure
25.
"Installing and removing
"Replacing
2
C power, and midplane power
for the location of the