Controlling Multiple Projectors; Setting The Projector Id - Epson PowerLite 7850p User Manual

Controlling Multiple Projectors

If you're using more than one projector for your presentation, you can
use the projector's ID system to switch between them using a single
remote control. To do this, you need to set a different ID for each
projector. During the presentation, it's easy to change the remote
control's ID to match that of the projector you want to use. When
you want to switch, simply change the remote control's ID to match
that of your second projector.

Setting the Projector ID

The projector's default ID is 1. Follow these steps to change it:
1. Press the button on the remote control.
Menu
You see the projector's menu screen.
2. Select the
Advanced2
and press
Projector ID
Video Video
Audio Audio
Effect Effect
Setting Setting
User's Logo User's Logo
Advanced1 Advanced1
Advanced2 Advanced2
About About
Reset All Reset All
[ ESC ]: Return [ ESC ]: Return
3. Press the right or left side of the
decrease the ID value.
4. Press to set the value.
Enter
5. When done, press
menu and press
Enter
.
Enter
:
Brightness Control Brightness Control High High Low Low
: 1 : 1
Projector ID Projector ID Set Set
Network Network Set Set
:
COM Port COM Port
RS-232C RS-232C
: :
Auto setup Auto setup ON ON OFF OFF
:
BNC Sync Termination BNC Sync Termination ON OFF ON
Reset Reset
Execute Execute
[ [ / / ]: Select ]: Select [ [ ]: Set ]: Set
pointer button to increase or
to exit the menu system.
E
SC
. Then highlight
USB USB
OFF
[Menu]: Exit [Menu]: Exit
Using the Projector's Menus
note
By default, the remote
control's ID is set to zero,
which allows it to control
any projector. If you want to
control multiple projectors
simultaneously, and you
don't want to switch
between them (each
projector would need its own
screen), you can leave the
remote control's ID set to
zero. In this situation, you
would not need to change
the projector's ID.
135