note
If a button is pressed longer
than 60 seconds, the remote
control stops operating to
conserve power. When you
release the button, normal
operation resumes.
Using the Remote Control
32
Activating and Using the Remote
Control
The remote control has an
Before using the remote, make sure batteries are installed as described
on page 34, then push up on the
Turn off the remote control before transporting or storing it; this
prevents the batteries from discharging if something presses against
one of the buttons.
Here are some additional tips:
Point the remote control either at the front or back of the
■
projector, or at the screen.
Stand within 30 feet of the projector. If you want to operate the
■
projector from a greater distance, a remote control cable set is
available (see page 14).
■
When presenting in a darkened room, press the
make the buttons on the remote light up temporarily.
■
Avoid using the remote under bright fluorescent lamps or in
direct sunlight, or the projector may not respond properly.
switch on its side, as shown.
ON/OFF
switch to turn it on.
ON/OFF
ON/OFF switch
light button to