Epson PowerLite 7850p User Manual page 88

note:
If you don't need the other
network ports, disable them
by deselecting their check
boxes. If more than one
network port is enabled, the
projector software warns you
to turn off AirPort when you
first connect the projector.
Disregard this message.
Your AirPort network and
base station names may be
different. To check or change
your AirPort network name,
start the AirPort Admin
utility, select your base
station, and click
. Click
Configure Show All
, then make any
Settings
changes you want on the
AirPort tab.
If you're connecting to your
projector in static IP mode,
deselect the
Distribute IP
check box. Make
addresses
sure your projector's gateway
address is identical to the base
station's IP address, and the
first three segments of the
projector's IP address are
identical to the first three
segments of the base station's
IP address.
Presenting Through a Wireless Network
88
2. Make sure Location is set to
Select
Automatic
Network Port
Select
Configurations
AirPort
then select
3. Select
Network Port Configurations
menu.
4. Under Port Configurations, select
5. Click
Apply Now
6. Start the AirPort Admin utility. Select your base station, then
click .
Configure
7. On the AirPort tab, make sure your AirPort network name
matches your projector's ESSID. If not, enter the projector's
ESSID in the AirPort Network text box and click
8. If you turned DHCP on in your projector's advanced menu, click
the Network tab and make sure the
check box is selected. If you need to select it, click
.
Automatic
in the Show pull-down
AirPort
. Then close the window.
Distribute IP addresses
.
.
Update
.
Update