Changing The Remote Control Id - Epson PowerLite 7850p User Manual
Epson multimedia projector user's guide
Hide thumbs
Also See for PowerLite 7850p:
- User manual (215 pages) ,
- Product support bulletin (38 pages) ,
- Product information manual (25 pages)
Table of Contents
Advertisement
Using the Projector's Menus
136
Changing the Remote Control ID
To change the remote control's ID to match that of a projector, follow
these steps:
1. Press the
button on the remote control. You see it light.
ID
2. Press one of the numbered buttons on the remote control to select
the ID of the projector you want to operate.
The
button's light shuts off and the new ID is registered.
ID
3. Repeat steps 1 and 2 each time you want to switch projectors.
To check the remote control's current ID, do the following:
1. Press the
button twice in succession. After a moment, the
ID
button flashes.
2. Count the number of flashes; this number corresponds to the
remote control's ID. (If it doesn't flash, the ID is set to zero.)
Zero
Advertisement
Table of Contents
