Controlling The Picture And Sound; Switching Between Picture Sources - Epson PowerLite 7850p User Manual

Controlling the Picture and Sound

You can use the remote control to preview and select your picture
sources, temporarily turn off the picture and sound, freeze the action,
zoom in on the picture, display a picture-in-picture image, and adjust
the volume.

Switching Between Picture Sources

If your projector is connected to more than one computer and/or
video source, you can switch between the different sources:
On the projector's control panel, there are two
■
Press the
Computer/DVI
equipment connected to the
the button to switch between equipment connected
Video/BNC
to the ,
Video S-Video
■ On the remote control, there are six
switch between equipment connected to the port identified on
each button, or to use EasyMP to project wirelessly or from a
memory card.
Note that the
Computer
input signals (for example, Analog RGB or RGB Video)—so if you
have equipment connected to one of these ports, it's important to
make sure the correct signal is selected to match the equipment you're
using. You can change the input signal settings using the projector's
menu system; see page 137.
After you select a source, the screen goes dark for a moment before the
image appears.
button to switch between EasyMP and
and
Computer
, and ports.
BNC
Source
and ports can be set up to use different
BNC
buttons:
Source
ports. Or press
DVI
buttons. Use them to
Using the Remote Control
note
You can use the projector's
menus to fine-tune the
picture and sound quality as
described in Chapter 4.
Source buttons
35