Connecting And Configuring The Projector On A Wired Network - Epson PowerLite 7850p User Manual

note
For information about
supported PCMCIA LAN
cards, contact EPSON as
described on page 191.
note
If you're a network
administrator, you can use
the option to enter a
SNMP
trap IP address. This lets you
receive trap alerts for the
projectors you're monitoring.
If you have HP OpenView,
a plug-in will be available
to allow you to manage your
projectors in HP OpenView.
Check with EPSON for
availability (see page 191).
You can also configure your
wireless network to receive
trap alerts. Your projector
must be connected in Access
Point mode. Select the
button next to
Advanced
the Access Point mode box,
then select and enter
SNMP
the IP addresses of the
computers to be notified of
an SNMP trap.
Managing Projectors
142
Connecting and Configuring the
Projector on a Wired Network
Before using the EasyManagement software to manage your
projector(s), you have to connect each projector you want to monitor
to your network and configure it with an appropriate IP address. You
can connect and configure the projector wirelessly, as described in
Chapter 4, or you can connect using a PCMCIA LAN card.
Follow these steps to use a PCMCIA LAN card to connect and
configure the projector for your network.
1. Insert the PCMCIA LAN card into the card slot on the back of
the projector. Then connect the projector to your network using a
commercially available 100baseTX or 10baseT network cable.
2. Turn on the projector (see page 18).
3. Press the button on the remote control and select
Menu
from the
Advanced2
Video Video
Brightness Control Brightness Control
Audio Audio
Projector ID Projector ID
Effect Effect
Network Network
Setting Setting
COM Port COM Port
User's Logo User's Logo Auto setup Auto setup
Advanced1 Advanced1
BNC Sync Termination BNC Sync Termination
Advanced2 Advanced2 Reset Reset
About About
Reset All Reset All
[ [ ]: Select ]: Select [ [ ]: Enter ]: Enter
4. If your network assigns addresses automatically, turn on
If your network does not assign addresses automatically, turn off
and enter the projector's
DHCP
Gateway Address
menu.
:
High High Low Low
: 1 : 1
Set Set
Set Set
: RS-232C RS-232C USB USB
:
ON ON OFF OFF
:
ON OFF ON OFF
Execute Execute
[Menu]: Exit [Menu]: Exit
IP Address
, and , as needed.
MAC Address
Network
Select Network
.
DHCP
, ,
Subnet Mask