Controlling Multiple Projectors; Setting The Projector Id - Epson PowerLite 7900p User Manual

Controlling Multiple Projectors

If you're using more than one projector, you can control all the
projectors—or just selected ones—by using the projector ID system.
To operate a projector, you have to set the remote control's ID to
match that of the projector. Or you can control all of the projectors
simultaneously by setting the remote control's ID to zero.

Setting the Projector ID

The projector's default ID is 1. If you need to change it, follow these
steps:
1. Press the button on the remote control.
Menu
You see the projector's menu screen.
2. Select the
Advanced2
and press
Projector ID
Video Video
Audio Audio
Effect Effect
Setting Setting
User's Logo User's Logo
Advanced1 Advanced1
Advanced2 Advanced2
About About
Reset All Reset All
[ ESC ]: Return [ ESC ]: Return
3. Press the right or left side of the
decrease the ID value.
4. Press to set the value.
Enter
5. When done, press
menu and press
Enter
.
Enter
:
Brightness Control Brightness Control High High Low Low
: 1 : 1
Set Set
Projector ID Projector ID
Set Set
Network Network
:
COM Port COM Port RS-232C RS-232C
:
Auto setup Auto setup :
ON ON OFF OFF
:
BNC Sync Termination BNC Sync Termination
ON OFF ON
Reset Reset
Execute Execute
[ [ / / ]: Select ]: Select [ [ ]: Set ]: Set
pointer button to increase or
to exit the menu system.
E
SC
. Then highlight
USB USB
OFF
[Menu]: Exit [Menu]: Exit
Using the Remote Control
63